Fuchen Brand Mobile Box Type Power Compact Distribution Transformer Substation
Product introduction

ZGS series substation is American type combined substation with function of high voltage control, protect, power transformation and distribution. Usually used in urban and rural power distribution system .The high voltage load switch and high voltage fuse of this product are installed in the oil of the transformer, with the two structure: in same case with the transformer and in different case with transformer. It can be used in high-rise buildings, building in urban and rural areas, residential communities , high-tech development areas, small and medium size factories, mining areas, oil fields, temporary construction sites, and other premises



Benefits

1. Compact and low cost
2. Low loss and strong over-load ability
3. Low noise, energy conservation and environmental protection
4. High mechanical strength, good performance

1. Ambient air temperature: -25°C ~ +40°C;
2. Relative humidity ≤ 95% (+25ºC)
3. Altitude ≤1000m;
4. Wind speed ≤ 35m/s;
5. Horizontal acceleration ≤ 0.4m/s², Vertical acceleration≤ 0.2m/s²;
6. Installation places should without conductive dust, corrosive nor explosion gas. No violent vibration, vertical gradient<3º.

If the switchgear will be used in conditions that exceed the normal environmental conditions, please consult with us.

Application
ZGSCombined type transformer substation is reliable power supply.It is very compact and low cost, easy for installation, operation and maintains. It's widely used in industrial park, high buildings, residential district, labor, wharf, airport, hotel, business center, etc.

The low voltage cabinet is specially equipped with intelligent under voltage controller, which has the function of identifying the abnormal voltage of the low voltage busbar of the substation, and can also avoid the tripping function of the low voltage switch caused by the trip of the 10kV high voltage line or during power outage maintenance.

Structure characteristic

Conditions of use
1. For indoor use, the altitude shall not exceed 2000m.
2. The ambient air temperature shall not be higher than + 40ºC or lower than - 5ºC. And the average temperature within 24 hours shall not be higher than + 35 ºC. In case of exceeding, the capacity shall be reduced according to the actual situation.
3. The relative high temperature of the surrounding air is + 40ºC and no more than 50%, and a larger relative temperature is allowed at a lower temperature; for example, 90% at + 20ºC, the influence of condensation due to the change of temperature should be considered.
4. When the device is installed, the inclination with the vertical plane shall not exceed 5°, and the whole group of cabinet columns shall be relatively flat and conform to the standard (GBJ232-2).
5. The device shall be installed in a place free from severe vibration and impact and corrosion of metal and electrical components.

Ordering instructions
1. Conceptual drawing or electrical schematic diagram of main circuit.
2. Model, specification and quantity of main components.
3. Incoming and outgoing line mode and cable specification, etc.
4. Other order requirements.